At 15.98 cents per kWh, Santa Fe Springs’ average residential electricity rate is over 4% more than that of the state. In fact, it’s almost 35% greater than the national average rate of 11.88 cents per kWh!

Granted, California’s residential energy usage is one of the lowest in the country. But that still means you’re paying more for each kilowatt you use.

And you know what? If you’re running a faulty air conditioner, then you’re paying even more.

Now the question is, how do you tell that you need AC repair in Santa Fe Springs?

That’s what we’re here to share with you today, so be sure to keep reading!

1. Weak Air Flow or Air isn’t Cool Enough

If there’s not enough cool air blowing out of your air conditioner’s vents, check the air filter first. You may only be dealing with a filthy air filter that either needs changing or washing. Clogged filters can block your AC’s air flow, so replace or wash them every three months.

If you recently changed your filter though, damaged fan blades may be to blame. These not only cause weak air flow, but can also lead to a faulty condenser. Condenser unit problems are some of the top causes of AC failure, so be sure to get that fan fixed ASAP!

If the problem is that your AC isn’t producing cool enough air, a bad compressor may be the culprit. The compressor is the part of your AC that turns the refrigerant into gas and then back into liquid. It needs to do this in a constant cycle so that you can keep enjoying cool air.

So, if the compressor is on its last legs, it may no longer be able to complete that cycle. Or, it may not even be transforming the refrigerant into gas anymore.

Either way, it’s best to call an HVAC repair pro in Santa Fe Springs to inspect your air conditioner. The experienced technician will determine the exact cause of the airflow issue.

2. Your AC Blows Out Warm Air Instead

A faulty compressor can also lead to your AC producing warm air instead of refreshing, cool air. But a more dangerous cause is a refrigerant leak. Especially if it’s running on the R22 refrigerant, or “Freon” as it’s more well-known for.

Air conditioners manufactured on or before 2015 use Freon, a chlorofluorocarbon (CFC). CFCs are chemicals that deplete the ozone layer, which is why this refrigerant is nearing a phase-out. Come January 01, 2020, production and supply of R22 will stop.

Refrigerant leaks also often produce hissing sounds, so if you hear those, call an AC repair pro. Better yet, consider replacing your air conditioner if it’s using Freon.

3. Skyrocketing Electricity Bills

12% of your electricity bill already goes towards AC use, so you wouldn’t want that to jump any higher. The thing is, a broken air conditioner part (like a failing motor) requires more energy to run. In most cases, it’s the unit’s attempt to compensate for its inefficient performance.

Let’s say your AC’s condenser motor is already dying. Since it’s failing, it’ll have a hard time removing heat from inside your home. So, it’ll make up for that inefficiency by running longer, thus consuming more energy.

The longer you put off having your AC repaired, the higher your electricity bills will be. Also, even if the unit is still working, it won’t be long until that motor completely dies. Wait until it does, and you’re looking at even more expensive repair expenses.

4. Powers On and Off

Your air conditioner’s thermostat is much like your system’s brain or command center. It controls the entire unit, telling it to generate cool air at the temperature you set it to. Once the room reaches that temperature, the thermostat will tell the unit to stop cooling.

As the room warms up again, the thermostat kicks back up so that the AC starts generating cooling air once more. So long as you have the air conditioner turned on, it’ll keep repeating this process.

If your thermostat malfunctions, it can’t read the room temperature right. This then leads to shorter cooling cycles, or “short-cycling”. If you run into this problem, you’ll notice your unit powers on or off by itself or it cycles on and off more quickly.

Either way, you’ll feel that the room doesn’t seem to be cool enough or that it warms up too fast. Call an AC repair expert to check your thermostat as it may already need replacement.

5. Foul Smells Coming from the Vents

Does your AC produce foul odors reminiscent to moldy bread or wet socks? This may be due to an overflowing or clogged condenser pan. That sitting water can lead to mold development, thus causing the mold-like smell.

This one’s often an easy fix, as you only need to drain and clean the condenser pan.

But if you smell something burning, turn off the AC right away and call an HVAC technician. That smell may be coming from burning wire insulation, which is a fire hazard. If the wire burns through all the way, you’ll end up with a completely broken AC.

Other Signs You Need AC Repair in Santa Fe Springs

Air conditioners, even the most “quiet” ones, still produce a gentle humming sound. But if you hear odd noises, such as squeals, scraping, and grinding sounds, that’s a different story.

A common culprit behind this is a loose or broken fan belt. The rubber may be rubbing or slapping against other internal parts of the AC. A grinding sound often indicates two metal parts rubbing against each other.

Whichever the cause of the sounds, contact an experienced AC repair technician ASAP. Delays in repairs can cause bigger damages to more sensitive internal parts of the unit.

Get Those AC Problems Fixed ASAP

As soon as you notice any of these symptoms, pick up that phone to request AC repair in Santa Fe Springs. Especially if you smell exhaust-like or burning odors. Not only are they telling signs of a broken AC, but they can also signal poisoning and fire hazards.

If you need immediate HVAC repair services, know that we can help. Don’t hesitate to connect with us now so we can get your AC or furnace back to excellent working order!